Table of Contents
Advertisement
Oven
Care & Cleaning
Changing
the Oven
Light
(some
models)
On some models, the oven light automatically turns on when the door is opened.
Some models have a switch located on the control panel to turn on the light. The
oven light is located at the rear of the oven.
To replace the oven light:
1.
Turn electrical power off at the main source or unplug the range.
2.
Replace bulb with a new 40 watt appliance bulb.
3.
Turn power back on again at the main source (or plug the range back in).
4.
The clock wilt then need to be reset. To reset, see Setting the Clock and
Minute Timer in this Use & Care Guide.
Fig. 1
or
use
a Nail
Fig. 2
about 4G
Hinge
Fig. 3
Be sure the range is unplugged and all parts are COOL before
replacing
oven light. Wear a leather-faced glove for protection against possible
broken glass.
Removing
and Replacing
the Oven Door
[Iri_ !_'_l'j'_'tl_1 The door is heavy.
For safe, temporary
storage, lay the door flat
_
with the inside of the door facing
down.
To Remove Oven Door:
1.
Open oven door completely (horizontal with floor- See Fig, 1).
2.
Remove 2 screws located on the inside of the oven door liner (See A Fig, 2)
3.
insert the 2 screws into the door hinge holes located on the side of the hinge arm, one
into each hinge (See B Fig, 2).
4.
Close oven door until the door stops (Do notforce the door to close any further). The
placement of these screws should keep door open in about a 45 degree position,
5.
Grasp oven door firmlyon both sides and slide door up and offhinges at the same angle,
(See Fig, 3)
6.
To clean oven door, follow the instructions
in the Care & Cleaning table (page 11),
To Replace Oven Door:
1.
Be sure the hinge arms remain at the 45 degree angle position. Be sure the screws are
still locking the hinge arms from moving. If the screws fall out of the hinge holes, the
hinge(s) may snap back against the oven frame and could pinch fingers or chip the
porcelain finish on the oven front frame.
2.
Hold door at the sides near the top while resting the lower front of door on your knee.
insert the door channels at the bottom of door over the door hinges, (See Fig. 3).
3.
Allowthe door to slide down into the door hinges evenly at the same45 degree angle.
The hinge arms should be inserted into the bottom corners as far as they can go.
4.
Open door completely (horizontal with floor) and remove both screws from holes in
door hinges.
5.
Reinstall the 2 screws into the door liner (See C Fig. 2).
6.
if the door is not in alignment with the oven frame, remove door and repeat the above
steps.
13
Advertisement
Table of Contents
