Crisper Cover Whit Lattice On Inner Surface; Door Racks; Modular Door Bins - Kenmore 795.73966300 Use & Care Manual

CRISPER COVER WITH LATTICE ON INNER
SURFACE
To remove the crisper cover:
1. Remove both crisper drawers.
2. While holding the crisper cover support (2), pull the cover
up and out (1).
DOOR RACKS
The door racks may be removed for easier cleaning,
Snap-On Door Racks
To remove the racks:
1. Remove all items in the door racks.
2. Push the rack away from the inside wall of the door (A)
and lift up the door rack (B).
WARNING: Be careful when handing glass cover since
glass is not attached to cover
To remove lattice on inner surface
1. Remove crisper cover (as illustrated above)
2. Hold the glass cover and overturn crisper cover
3. For each lattice hold lattice and pull sides of the cover
outward to remove lattice,
To replace the racks:
1. Hold either end of the door rack against the inside wall
of the door.
2. Push down the rack end until it locks in place,
MODULAR DOOR BINS
1. Bins can be moved side to side by sliding right or left,
2. To remove the bin, lift until bin up bottom of bin unclicks
and pull straight out,
To replace lattice on inner surface,:
1. For each lattice insert middle tab in 1
(closest to glass cover) and pull sides of the cover to
insert lattice,
3. To replace the bin, slide it in above the desired
support slot and firmly push down until it locks in place,
WARNING: Be sure to clicks bottom portion of bin
otherwise, bins may fall
NOTE: Do not adjust a bin that is loaded with food.
16