Assembly; Attachment Assembly - Sears Kenmore 11637213793 Owner's Manual

Using a screwdriver, tighten the screw.
DO NOT overtlghten. Overtlghtenlng could strip the
screw holes.
DO NOT operate the cleaner without the screw In
place.
CORDASSEMBLY
Make sure the quick
release upper cord
hook isin the upright
position. Remove the
wire tie from the power
cord. Lock the cord
into place by forcing it
into the Iocldng notch
on the body of the
cord hook as shown.
"_ Locking I _'_
| Notch I
Upper
Cord
Wrap the power
cord around the
upper and
lower cord
hooks.
TTACHMENT
ASSEMBLY
TO ASSEMBLE ATTACHMENTS
After the handle has been assembled to
the body and the power cord has been
wrapped around the cord hooks, the
attachments can be assembled.
I. The wand can be attached to the
hose by inserting the small end of the
wand into the open end ofthe hose.
Be sureto align the tabs on thewand with
the "J*slots i nthe hose.Once the wand is
inserted into the hose it shouldbe twisted to
the right to lockthe tabsinto the "J*slots.
H_
support
2. The wand and hose can then be routed in front
of the handle and over the hose support.
3. The wand can then be placed over the end of
the short hose, twisting as you push down.
4. The second wand, without tabs, (some models) can be
placed in the holder in front of the wand with tabs and the
dusting brush or combination brush can be stored in the
wand or the holder, (some models).
5. The crevicetoolcan be slipped down into the holder
beside the wand.
DuwUngBrush
(Some Models)
Short