Kenmore 46981 Use, Care, Safety Manual page 21

Downdraff vents and filters should be cleaned frequently;
after every use is best.
To D'emo_.r_:
1, Pull out vent grills and lift out aluminum grease
filters,
To _'ep_ace:
1.
,
The angled flanges at the top and bottom edges of
the filter should facetoward the inside of the unit with
the top edge slanted outward.
Reinsert the vent grill.
VENT
GRILL
/
/
/
/
/
/
/
GREASE
FILTER
REmOVAbLE I EFLECTOR BOWLS
1"0 _*e_T_ove,"
1. Grasp element, tilt it upward slightly to clear the
reflector bowl, then pull away from the receptacle.
The element will not sit level when replaced if it is
forced too far upward when removed.
2. Lift out the reflector bowl,
To repllace:
1, Replace the reflector bowl, Be sure the receptacle is
showing in the bowl opening.
2. Slide the plug of t he element firmly into t he receptacle
and lower the element into place.
ELEMENTS
REFLECTOR BOWLS
RECEPTACLE
Note: Do not pull elements up more than 1" or
damage to the receptacle wigl occur.
DO NOT lift a plug.in unit more than 1% if
you do, it may not lie flat on the drip bowl
when you plug it back in.
Repeated lifting of the plug=in unit more
than 1" above the drip bowl can perma.
nenUy damage the receptacle.
20 NEMNT30-2