Kenmore 46981 Use, Care, Safety Manual page 20

R @VA IL - G ILL ODULE
THE GRt]LL _JaODULE
To insert the gril! module:
1. Be sure the controls are off°
2. Place the two reflector plates in the well.
3. Grasp the grill element with both hands. Keep the
element as horizontal as possible and push the plug
firmly into the receptacle to insure complete contact.
The element should lie flat and rest on the edges of
the reflector plate.
4. Place the two grill grids into the opening in the
cooktop over the grill element.
To remove _he grill module:
1. Be sure the controls are off and the element is cool.
2. Grasp the element with both hands near the plug.
3. Raise the opposite side of the element just enough to
clear the well. Pull away from the receptacle.
The eJement will not sit level when replaced if it
is forced too far upward when removed.
REFLECTOR
PLATES
REMOVABLE GRilDDLE MODULE
THE GRHDDLE _'_ODULE
To insert the griddlle:
1. Be sure the controls are off.
2. Insert the reflector plates and the element from the
grill module.
3. Place the griddle into the cooktop with the two drain
holes toward the front of the cooktop.
NOTE:When properly placed the griddle sits
slightly above the cooktop and is in con,
tact with the grill element. You may
notice a gap between the griddle and the
open well, This is necessary to allow heat
to escape,
To remove the griddle:
1_ Be sure the controls are off and the element is cool
2. Lift the back edge of the g riddle a bit to let any excess
fat or oil drain, then remove the griddle.
3. Grasp the element with both hands on either side of
the plug.
4. Raise the opposite side of the element just enough to
clear the well. Pull away from the receptacle.
19 NEMNT29