Amana NTW4501XQ0 Use And Care Manual page 11

TROUBLESHOOTING
r First try the solutions suggested here or visit our website to possibly avoid the cost of a service call... _'
http://www.amana.com/help
Check the following
for proper installation:
(cont.)
Washer won't run
or fill, washer stops
working or wash light
remains on (indicating
that the washer was
unable to fill
appropriately)
Fill hose washers.
Drain hose connection.
Make sure all four fill hose flat washers are properly seated.
Pull drain hose from washer cabinet and properly secure it to drainpipe
or laundry tub.
-Do not place tape over drain opening.
Check household plumbing Water can back up out of a clogged sink or drainpipe. Check all
for leaks or clogged sink or drain, household plumbing for leaks (laundry tubs, drain pipe, water pipes,
and faucets.)
Washer not loaded as
recommended.
Improper loading can cause basket to be out of alignment and
cause water to splash off tub. See "Using Your Washer" for loading
instructions.
Check for proper water supply.
Both hoses must be attached and have water flowing to inlet valve.
Both hot and cold water faucets must be turned on.
Check that inlet valve screens have not become clogged.
Check for any kinks in inlet hoses, which can restrict water flow.
J
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
r
If you experience
Washer won't run
or fill, washer stops
working or wash light
remains on (indicating
that the washer
was unable to fill
appropriately) (cont.)
Possible Causes
Check proper electrical supply.
Normal washer operation.
Washer may be tightly
packed.
Solution
Plug power cord into a grounded 3 prong outlet.
Do not use an extension cord.
Ensure there is power to outlet.
Reset a tripped circuit breaker. Replace any blown fuses.
NOTE: If problems continue, contact an electrician.
Lid must be closed for washer to run.
Washer will pause during certain phases of cycle. Do not interrupt
cycle.
Washer spins the dry load for several minutes before filling to determine
if load is balanced. You may hear the hum of the spins. This is normal.
Remove several items, rearrange load evenly in basket, and add
detergent. Close lid and press START/PAUSE/UNLOCK.
Do not add more than 1 or 2 additional garments after cycle has started
to avoid tightly packing or unbalancing. J
11