Connecting Fm/Am Antennas; Getting Started; Before Installation; Checking The Supplied Accessories - JVC RX-7030VBK Instructions Manual

Getting Started
This section explains how to connect audio/video components and speakers to the receiver, and how to connect the
power supply,
General Precautions
• Be sure your hands are dry.
• Turn the power off to all components.
• Real the manuals supplied with the components you are going to
connect.
Locations
• Install the receiver in a location that is level and protected from
moisture,
• The temperature around the receiver must be between -5°C and
35°C (23°F and 95°F ).
• Make sure there is good ventilation around the receiver, Poor
ventilation could cause overheating and damage the receiver.
Handling
the receiver
• Do not insert any metal object into the receiver.
• Do not disassemble the receiver or remove screws, covers, or
cabinet.
• Do not expose the receiver to rain or moisture.
Check Io be sure you have all of the following items, which are
supplied with the receiver.
The number in the parentheses indicates quanthy of the pieces
supplied.
• Remote Control (1)
• Batteries (2)
• AM LoopAntenna
(1)
• FM Antenna (1)
If anything is missing, contact your dealer immediately.
Before using the remote control, insert the two supplied baneries
first.
3
1 2
R6P(SUM-3)/
1. Press and slide the battery cover on the back of
the remote control.
2. Insert the batteries.
•
Make sure to match the
polarity: (+) to (+) and (-) to (-).
3. Replace the cover.
If the remote control cannot transmit signals or operate the receiver
correctly, replace the baneries. Use two R6P(SUM-3)/AA(I 5F) type
dry-cell baneries.
Notes:
• Suppliedbatteriesarefortheinitialsetup. Replaceforcontinued
use,
• After replacing the batteries, set the manufacturers'codes again
(see pages from 47 to 49),
CAUTION:
Follow these precautions to avoid leaking or cracking cells:
• Place batteries in the remote control so they match the polarity:
(+) to (+) and (-) to (-),
• Use the correct type of batteries. Batteries that look similar may
differ in voltage,
• Always replace both batteries at the same time.
• Do not expose batteries to heat or flame.
FM Antenna Connections
/
FM 75,_ / Outdoor FM Antenna CaNe
COAXIAL J (not supplied)
A. Using the Supplied FM Antenna
The FM antenna provided can be connected to the FM 75 £_
COAXIAL terminal as temporary measure.
B. Using the Standard l_pe Connector (Not Supplied)
A standard type connector should be connected to the FM 75 £_
COAXIAL terminal
Note:
If reception is poor, connect the outdoor FM antenna (not supplied).
Before attaching a 75 £2 coaxial cable with a connector (the kind with
a round wire going to an outdoor antenna), disconnect the supplied
FM antenna.
8