Ducting Information; Important Safety Instructions - Jenn-Air JGD8430ADF15 Use & Care Manual

IMPORTANT SAFETY INSTRUCTIONS
fuels. Properly adjusted burners will minimize
incomplete combustion. Exposure to these substances
can also be minimized by properly venting the burners
to the outdoors.
IMPORTANT NOTICE REGARDING PET BIRDS:
Never keep pet birds in the kitchen or in rooms where
the fumes from the kitchen could reach. Birds have a
very sensitive respiratory system. Fumes released during
an oven self-cleaning cycle may be harmful or fatal to
birds. Fumes released due to overheated cooking oil,
fat, margarine and overheated non-stick cookware may
be equally harmful.
Electrical Connection
Appliances which require electrical
power are equipped with a three-prong
grounding plug which must be
plugged directly into a properly
grounded three-hole 120 volt
electrical outlet.
Always disconnect power to appliance before servicing.
The three-prong grounding plug offers protection
against shock hazards. DO NOT CUT OR REMOVE
THE THIRD GROUNDING PRONG FROM THE
POWER CORD PLUG.
If an ungrounded, two-hole or other type electrical
outlet is encountered, it is the personal responsibility
of the appliance owner to have the outlet replaced
with a properly grounded three-hole electrical
outlet.
Ducting Information
Jenn-Air's ventilation system is designed to capture
both cooking fumes and smoke from the cooktop
surface. If the system does not, these are some ducting
installation situations to check:
• 6" diameter round or 3 W' x 10" rectangular ducting
should be used for duct lengths 10'-60'.
Note: Use 5" diameter round ducting if the duct
length is 10' or less.
• No more than three 90 ° elbows should be used.
Distance between elbows should be at least 18".
• Recommended Jenn-Air wall cap MUSTbe used.
Make sure damper moves freely when ventilation
system is operating.
• There should be a minimum clearance of 6" for
cooktop installed near a side wall.
• There should be a minimum clearance of 12" between
the bottom of the wall cap and the ground.
If there is not an obvious improper installation, there
may be a concealed problem such as a pinched joint,
obstruction in the pipe, etc. Installation is the responsi-
bility of the installer and questions should be addressed
first by the installer. The installer should very carefully
check the ducting installation instructions.
• Use the Flow Tester Card provided with
your appliance to check the air flow.
FLOW TESTER
t
Save These Instructions for Future Reference
4