Advertisement
Available languages
Available languages
[ COOKTOP
I
To prevent the cooktop from discol-
oring or staining:
°
Clean cooktop after each use.
° Wipe acidic or sugary spillsassoon
asthe cooktop hascooled asthese
spills may discolor the porcdain.
S[MN_ER
BURNER
This burner is located in the left front
position. The simmer burner offers a lower
BTU flame for delicate saucesor melting
chocolate.
* BTU ratings will vary when using, L Pgas.
BURNER GRATES
The grates must be properly positioned
Unl&earangewithstan-
before cooking. Improper installation of
dard gas burners, this
the grates may result in chipping of the
cooktop does not lift-
cooktop.
up nor is it removable.
Do not attempt to li_t
the cooktop [or any
reQson.
SEALED
BURNERS
The sealed burners of your range are se-
cured to the cooktop and are not designed
to be removed.
Since the burners are
sealedinto the cooktop, boilovers or spills
will not seep underneath the cooktop.
However, the burner heads should be
cleaned after each use. The head portion of
the burner is easily removed for cleaning.
(See page 16 for cleaning directions.)
H: GH
PERFOR ' ANCE
BURNER
{712,000 BTU*}
There is one high speed burner on your
range, located in the right front position.
This burner offers higher speed cooking
that can be used to quickly bring water to a
boil and for large-quantity cooking.
Do not operate the burners
without
a
pan on the grate.
The grate's
porce-
lain finish may chip without
a pan to
absorb
the heat
from
the
burner
flame.
Although the burner grates are durable,
they will gradually lose their shine and/or
discolor, due to the high temperatures of
the gas flame.
NOTES:
• A properly adjusted burner with clean ports will light within a few seconds. If using
natural gas, the flame will be blue with a deeper blue inner cone.
Ifthe burner flame isyellow or is noisy, the air/gas mixture may be incorrect. Contact
a service technician to adjust. (Adjustments are not covered by the warranty.}
With LP gas, some yellow tips on the flames are acceptable. This is normal and
adjustment is not necessary.
• With some types of gas, you may hear a "popping" sound when the surface burner
is turned off. This is a normal operating sound of the burner.
• If the control knob is turned very quickly from hi to Io, the flame may go out,
particularly if the burner is cold. If this occurs, turn the knob to the OFF position,
wait several seconds and relight the burner.
• The flame should be adjusted so it does not extend beyond the edge of the pan.
Advertisement
