PRODUCTDATA SHEETS
Base Grille Water Filtration System
Model WF-L200V
Capacity
200 Gallons
(757 Liters)
Model WF-NL120V
Capacity
120 Gallons
(454 Liters))
Tested and certified by NSF International
against ANSI/NSF Standard
42 for the reduction of Chlorine, Taste and Odor, Particulate Class II1";
and against ANSl/NSF Standard 53 for the reduction of Lead,
Mercury, Benzene, and p-dichlorobenzene.
This system
has been tested
according
to ANSl/NSF
42/53
for the reduction
of the substances
listed
below.
The concentration
of
the indicated
substances
in water
entering
the system
was reduced
to a concentration
less than
or equal to the permissible
limit for
water
leaving
the system,
as specified
in ANSl/NSF
42/53.
Substance
Reduction
NSF Reduction
Average
Influent Challenge
Maximum
Average
Minimum %
Average %
Aesthetic
Effects
Requirements
Influent
Concentration
Effluent
Effluent
Reduction
Reduction
Chlorine Taste/Odor
_>50%
1.9 mg/L
2.0 mg/L + 10%
0.07 mg/L
0.06 mg/L
>75.0%
>75.0%
98.7%
Particulate Class II1"
_>85%
49,333/mL
At east 10,000 partc es/mL
640 mg/L**
312 mg/L
99%
Contaminant
NSF Reduction
Average
Influent Challenge
Maximum
Average
Minimum %
Average %
Reduction
Requirements
Influent
Concentration
Effluent
Effluent
Reduction
Reduction
Lead: @ pH 6.5
0.01mg/L
0.14 mg/L***
0.15 mg/L + 10%
0.0014 mg/L
0.0011 mg/L
99.0%
99.21%
Lead: @ pH 8.5
0.01mg/L
0.15 mg/L***
0.15 mg/L _+10%
0.0069 mg/L
0.0042 mg/L
95.4%
97.08%
Mercury: @ pH 6.5
0.002 mg/L
0.0059 mg/L
0.006 mg/L + 10%
0.0009 mg/L
0.0004 mg/L
84.74%
92.47%
Mercury: @ pH 8.5
0.002 mg/L
0.0054 mg/L
0.006 mg/L _+10%
0.0007 mg/L
0.00043 mg/L
87.03%
91.93%
Benzene
0.0050 mg/L
0.0157 mg/L
0.015 _+10%
0.002 mg/L
0.00083 mg/L
87.26%
94.71%
p-dichlorobenzene
0.075 mg/L
0.210 mg/L
0.225 _+10%
0.0005 mg/L
0.0005 mg/L
99.76%
99.76%
Test Parameters: pH =
(17.2°C).
•
It is essential that operational, maintenance, and filter
replacement requirements
be carried out for the product to
perform as advertised.
•
Model WF-L2OOV: The filter monitor system measures the
amount of water that passes through the filter and alerts you
to replace the filter. When 90% of the filter's rated life is used,
the filter indicator light changes from green to yellow. When
100% of the filter's rated life is used, the filter indicator light
changes from yellow to red, and it is recommended
that you
replace the filter. Use replacement cartridge L200V/NL120V,
part #4396702. 2004 suggested retail price of $32.99 U.S.A./
$49.99 Canada. Prices are subject to change without notice.
Model WF-NL120V:
Change the water filter cartridge every
6-9 months. Use replacement cartridge L200V/NL120V,
part
#4396702. 2004 suggested retail price of $32.99 U.S.A./
$49.99 Canada. Prices are subject to change without notice.
•
The product is for cold water use only.
7.5 _+0.5 unless otherwise noted. Flow = 0.5 gpm (1.9 Lpm). Pressure = 60 psig (413.7 kPa). Temp. = 63°F
•
Do not use with water that is microbiologically
unsafe or of
unknown quality without adequate disinfection
before or after
the system.
•
Refer to the front cover or "Accessories"
section for the
Manufacturer's
name, address and telephone number.
•
Refer to the "Warranty" section for the Manufacturer's
limited
warranty.
Application Guidelines/Water
Supply Parameters
Water Supply
City or Well
Water Pressure
30 - 120 psi (207 - 827 kPa)
Water Temperature
33 ° - 100°F (0.6 ° - 37.8 ° C)
Service Flow Rate
0.5 GPM (1.89 L/min.) @ 60 psi.
*Class III particle size: >5 to <15 um
**Test requirement
is at least 10,000 particles/mL
of AC Fine Test Dust.
***These contaminants
are not necessarily in your water supply. Performance
may vary based on local water conditions.
® NSF is a registered trademark
of NSF International.
18