Inglis IPT104302 Use & Care Manual page 5

NOTE: Donotinstall therefrigerator near a noven, r adiator, or
other h eat s ource, norinalocation w here t hetemperature will f all
below 55°F (13°C).
/
/
2" (5.08 cm)
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
Before you move your refrigerator into its final location, it is
important to make sure you have the proper electrical
connection.
Recommended Grounding Method
A 115 Volt, 60 Hz., AC only 15 or 20 amp fused, grounded
electrical supply is required. It is recommended that a separate
circuit serving only your refrigerator be provided. Use an outlet
that cannot be turned off by a switch. Do not use an
extension cord.
NOTE: Before performing any type of installation, cleaning, or
removing a light bulb, turn the control (Thermostat, Refrigerator
or Freezer Control depending on the model) to OFF and then
disconnect the refrigerator from the electrical source. When you
are finished, reconnect the refrigerator to the electrical source
and reset the control (Thermostat, Refrigerator or Freezer Control
depending on the model) to the desired setting.
TOOLS
NEEDED: ¾6" hex-head socket wrench, No. 2 Phillips
screwdriver, fiat-blade screwdriver, %6" open-end wrench, flat 2"
putty knife.
IMPORTANT:
• Before you begin, turn the refrigerator control OFE
Unplug refrigerator or disconnect power.
• Remove food and any adjustable door or utility bins from
doors.
• All graphics referenced in the following instructions are
included later in this section after "Final Steps."
Door and Hinge Removal
5/16" Hex-Head Hinge Screw
1.
2.
3=
Unplug refrigerator or disconnect power.
Open refrigerator door and remove base grille from the
bottom front of the refrigerator. See Base Grille graphic.
Close the refrigerator door and keep both doors closed until
you are ready to lift them free from the cabinet.
NOTE: Provide additional support for the doors while the
hinges are being moved. Do not depend on the door magnets
to hold the doors in place while you are working.
4. Remove the parts for the top hinge as shown in Top Hinge
graphic. Lift the freezer door free from the cabinet.
5. Remove the parts for the center hinge as shown in the Center
Hinge graphic. Lift the refrigerator door free from the cabinet.
6. Remove the parts for the bottom hinge as shown in the
Bottom Hinge graphic.
IMPORTANT: If you want to reverse your doors so that they open
in the opposite direction, continue with the "Door reversal
(optional)" instructions. If you are not reversing the doors, see the
"Door and Hinge Replacement" section.