Assembly; Fitting The Loop Handle; Assembling And Dismantling The Two-Piece Shaft; Fitting The Trimmer Guard And Trimmer Head - Husqvarna 128CD Operator's Manual

ASSEMBLY
NOTE: Make sure unit is assembled cor-
rectly as shown in this manual.
Fitting the loop handle
• Position the handle on the upper shaft.
Note that the handle must be mounted
between the two arrows on the shaft.
I
• Fit the screw, securing plate and wing
nut as shown in the diagram.
• Tighten the wing nut.
Assembling and dismantling
the two-piece shaft
Assembly:
• Loosen the coupling by turning the knob.
• Position locking/release button (A) of
attachment into guide recess (B) of
coupling.
B
• Push the attachment into the coupling
until the locking/release button snaps
into the primary hole (C).
• Before using the unit, tighten the knob
securely.
I& WARNING:
All attachments are
designed to be used in the primary
hole unless otherwise stated in the
applicable attachment instruction
manual. Using the wrong hole could
lead to serious injury or damage to
the unit,
545186844 Rev. 5 2/17/09
Dismantling:
• Loosen the coupling by turning the knob.
Press and hold the locking/release but-
ton (A).
While securely holding the engine and
upper shaft, pull the attachment straight
out of the coupling.
Fitting the trimmer guard and
trimmer head (Model 128LD)
• Fit the correct trimmer guard (D) for use
with the trimmer head. Hook the trimmer
guard/combination guard onto the fitting
on the shaft and secure with the bolt (E).
/F
i
D D
• Fit the drive disc (F) on the output shaft.
• Turn the shaft until one of the holes in the
drive disc aligns with the corresponding
hole in the gear housing.
• Insert hex wrench (G) in the hole to lock
the shaft.
• Screw on the trimmer head (H) in the op-
posite direction to the direction of rota-
tion.
H
i
• To dismantle, follow the instructions in
the reverse order.
English - 13