Husqvarna LOGTH2448T Operator's Manual page 29

TROUBLESHOOTING CHART:
See appropriate section in manual unless directed to a service center
)ROBLEM CAUSE CORRECTION
Loss of power
continued)
Excessive
vibration
Engine dies when
tractor is shifted
into reverse
Engine continues
to run when
operator leaves
seat with
attachment
clutch engaged
Poor cut - uneven
6. Faulty spark plug,
7, Dirty fuel filter.
8. Stale or dirty fuel
9. Water in fuel.
10.Spark plug wire loose.
11, Dirty engine air screen/fins_
12. Dirty/clogged muffler.
13. Loose or damaged wiring.
14. Carburetor out of adjustment.
t 5. Engine valves out of
adjustment.
1o Worn, bent or loose blade.
2. Bent blade mandrel.
3. Looseldamaged part(s).
Reverse operation system
(ROS) is not "ON" while
mower or other attachment
is engaged.
1. Faulty operator-safety
presence control system.
2,
3.
4.
5,
Worn, bent or loose blade,
Mower deck net level,
Buildup of grass, leaves, and
trash under mower.
Bent blade mandrel.
Clogged mower deck vent
from build-up of grass, leaves,
and trash around mandrels.
6. Clean and regap or change
spark plug.
7, Replace fuel filter.
8, Empty fuel tank and refill tank
with fresh, clean gasoline.
9. Empty fuel tank and carbure-
tor, refill tank with fresh gas-
oline and replace fuel filter,
10. Connect and tighten spark
plug wire°
t 1 ,Clean engine air screenlfinso
12, Clean/replace muffler°
13.Check all wiring.
14. See "To Adjust Carburetor"
in Service and Adjustments
section,
i5. Contact a qualified service
center,
1, Replace blade, Tighten blade
bolt,
2, Contact a qualified service
center.
3. Tighten loose part(s),
Replace damaged parts.
Turn ignition key to
ROS "ON" position.
See Operation section,
Check wiring, switches and
connections. If not corrected,
contact a qualified service
center,
1, Replace blade,, Tighten blade
bolt,
2. Level mower deck.
3. Clean underside of mower
housing.
4. Contact a qualified service
center,
5. Clean around mandrels to
open vent holes.
29