Husqvarna LOGTH2448T Operator's Manual page 20

WARNING: TO AVOID SERIOUS INJURY, BEFORE PERFORMING ANY SER- VICE OR ADJUSTMENTS:
1, Depress brake pedal fully and set parking brake°
2o Place attachment clutch in "DISENGAGED" position,
3o Turn ignition key to "STOP" and remove key,
4. Make sure the blades and all moving parts have completely stopped°
5. Disconnect spark plug wire from spark plug and place wire where it cannot
come in contact with plug.
TRACTOR
TO REMOVE MOWER
1, Place attachment clutch in "DISEN-
GAGED" position.
2. Lower attachment lift lever to its lowest
position_
3. Disengage belt tension rod (K) from
lock bracket (L).
_tb CAUTION: Belt tension rod is spring
loaded. Have a tight grip on rod and re-
lease slowly,
4. Remove mower belt from electric
clutch pulley (M).
5. Disconnect front link (E) from mower
* remove retainer spring and washer.
6. Go to either side of mower and discon-
nect mower suspension arm (A) from
chassis and rear lift link (C) from rear
mower bracket (D) - remove retainer
springs and washers.
7. Go to other side of mower and discon-
nect the suspension arm and rear lift
link.
,_ CAUTION: After rear lift links are dis-
connected, the attachment lift lever will be
spring loaded. Have a tight grip on lift lever
when chanaino Position of the lever._
8o Turn tractor steering wheel to the left
as far as it will go,
9. Slide mower out from under right side
of tractor,
TO INSTALL MOWER
Be sure tractor is on level surface and
engage parking brake.
1. Lower attachment lift lever to it's lowest
_ position.
CAUTION: Lift lever is spring loaded.
Have a tight grip on lift lever, lower it
slowly and engage in lowest position.
2, Turn tractor steering wheel to the left
as far as it will go and position mower
on right side of tractor with deflector
shield to the right.
20