Hitachi 60EX38B Operating Manual page 21

USING THE REMOTE TO CONTROL CABLE BOX FUNCTIONS
Operating the precoded function for your cable box
This remote isdesigned to operate different types of Cable Boxes. You must first program the remote to match the remote
system in your cable box. (Refer to page 22.)
1. Turn ON your cable box.
2. Aim the remote control at the front of your cable box.
3,
While holding down the CABLE button on the remote, enter the 2 digit preset code that matches your cable box as
shown on page 22. The remote will turn offyour cable box when the correct 2 digit preset code is entered. When this
occurs, the remote control is programmed for your cable box. If the cable box does not turn off after 5 seconds, try
a different 2 digit preset code.
4. The remotewill now controlyour cable box.
NOTES:
1. If yourcable box cannotbe operated afterper-
forming the above procedures,this meansthat
your cable box codes have not been precoded
intothe remote.
2. Inthe unlikelyeventthatyour cable boxcannot
be operated after performingthe above proce-
dures, consultyourcable box operatingguide.
3. The remotecontrolwillrememberthecodesyou
have programmedin untilthe batteriesare re-
movedfrom the remotecontrol. After replacing
the batteriesrepeatthe entireprogramming pro-
cedurestatedabove.
4. Ifyourcable boxdoesnothavea powerfunction,
the remote will issue the CHANNEL _IL func-
tion.
@
®
®
®
®
CABLE BUTTON
Thisbuttonallowsthe remoteto controlyourcable
box by settingitto CABLE mode.
TV/VCR BUTTON
When the remote is in CABLE mode, this isthe A/B
button.
ENTER BUTTON
If your cable box does not have an enter function,
this button will send the TV enter code.
RECALL BUTrON
If your cable box does not have a last channel
function, this buttonwillsend the TV channelrecall
code.
PRECODED CABLE BOX BUTTONS
Thesebuttonstransmit t he chosenprecoded CATV
codes.
@
EXCLUSIVE TV Bu'n'ONS
These buttonsare for operatingthe TV.
21