Power Control - HAMPTON BAY Room Air Conditioners Installation & Operation Manual

4. ELECTRONIC CONTROL PANEL
The pictured control panel is similar to your panel.
VENT
PULL
OPEN
• CHECK FILTER
• 11MER _1_
Zo©
I -
• ENERGY SAVE
• COOL • FAN
ON/OFF ®
Set
Temperature
/Timer
Display
Temperature
/Timer Hour
Controls
Check Filter
Light/Reset
-- Timer
Control
-- Fan Speed
Control
-- Mode
Control
Power
Control
Remote control sold separately.
Power Control
The Power Control turns the unit on and off.
Set Temperature/
Timer Display
Shows the set temperature when the unit is in
operation and hours when the timer is being set.
THE TEMPERATURE DISPLAY ONLY SHOWS THE
SET TEMPERATURE, NOT THE ACTUAL ROOM
TEMPERATURE.
Temperature/
Timer Hour Controls
These buttons are used to raise or lower the set
temperature in increments of 1 o from 66 ° to 88 °.
By depressing both buttons at once, the display
will toggle between Celsius and Fahrenheit. When
the timer is being set, these buttons are used to
change the hour setting in increments of 1 from
00 to 24.
Check Filter Light/Reset
After 250 hours of usage the Check Filter light
will turn on. At this time, the filter needs to be
removed and cleaned (see page 8). After the filter
is cleaned and repositioned, depress the Reset
button. This will restart the counter and turn the
light off.
Mode Control
The Mode Control has three settings:
FAN, COOL and ENERGY SAVER. A green
light will indicate which mode is currently
being utilized.
Cool Mode - The unit will circulate and cool
the air.
Fan Mode - The unit will only circu]ate the air.
Energy Saver Mode -The fan will switch
from the set fan speed to LO whenever the com-
pressor turns off in response to the thermostat.
When the compressor cycles back on, the unit
will return to the original fan setting.