Installation Instructions; Unpack The Air Conditioner; Prepare Air Conditioner For Installation - Haier ESA415J Use & Care Manual

PowerSupplyCord
NOTE: Your a irconditioner's device m ay differ f rom theone
shown.
/4
A. Test button
B. Reset button
This room air conditioner is equipped with a power supply cord
required by UL. This power supply cord contains state-of-the-art
electronics that sense leakage current. If the cord is crushed, the
electronics detect leakage current and power wilt be
disconnected in a fraction of a second.
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong,
Do not use an adapter,
De not use an extension cord,
Failure to fellow these instructions can result in death,
fire, or electrical shock.
To test your power supply cord:
1. Plug power supply cord into a grounded 3 prong outlet.
2. Press RESET (on some devices).
3. Press TEST (listen for click; Reset button wilt trip).
4. Press and release RESET (listen for click; Reset button wilt
latch). The power supply cord is ready for operation.
NOTES:
[] The Reset button must be pushed in for proper operation.
[] The power supply cord must be replaced if it fails to trip when
the test button is pressed or fails to reset.
[] Do not use the power supply cord as an off/on switch.
[] A damaged power supply cord must be replaced with a new
power supply cord obtained from the product manufacturer
and must not be repaired.
[] The power supply cord contains no user serviceable parts.
Opening the tamper-resistant case voids all warranty and
performance claims.
INSTALLATION I NSTRUCTIONS
Excessive Weight Hazard
Use two or more people to move and install
air conditioner,
Failure to do so can result in back or other injury,
Remove Packaging Materials
[] Remove and dispose of/recycle packaging materials. Remove
tape and glue residue from surfaces before turning on the air
conditioner. Rub a small amount of liquid dish soap over the
adhesive with your fingers. Wipe with warm water and dry.
[] Do not use sharp instruments, rubbing alcohol, flammable
fluids, or abrasive cleaners to remove tape or glue. These
products can damage the surface of your air conditioner.
[] Handle the air conditioner gently.
Prepare unit for installation
Unpack unit on the floor next to instattationlocation.
1. Remove two front attachment screws.Separate the outer case
from the front with a putty knife at the catch points designated by the
arrows.
2. Remove the four screws on both sides d the outer case.
3. Using the basepan handle, slowly and evenly putt chassis out
from outer case.