Hotpoint RGB745 Owner's Manual & Installation Instructions page 46

Before you call for service...
Troubleshooting -tips
_ _ Ji Possible Causes What To Do
Excessive smoking I_cessive soil. * Touch tile CLEAR/OFFpad. Open tile windows to rid
CLEANpad goes off. _'Vipe up tile e×cess soil and reset
tile room of smoke. \_'ait until the light, on the SELF
the clean cycle.
Oven door willnotopen Oven too hot. * Adlow the oven to cool below locking temperature.
after a clean cycle
Oven not clean after Oven conlrols not properly set. * See the Using the self-cleaning oven section.
a clean cycle Oven was heavily soiled. * (]lean up heavy spilhwe_ befiwe starting the clean cycle.
Fleavilv soiled ovens may need to sell:clean again or fin.
a longer period of time.
Oven door willnot Oven is too hot. * _Ml(>wthe oven to cool below locking temperature.
unlock (on models Do not lock the oh>or with the door latch except when
with a doorlatch)
usin,, the self:clean teature.
"Door"appears in the
Self-cleanhag cycle has been
* Move the latch handle
all the way to the fight.
display (on models selected but the latch handle
with a door latch) was not moved all the way
to the fight.
Latch handle was moved to the * Move tile latch handle to the right only when
,setfilW
fight but a progrmn other than the sell_cleaning cycle.
self-clemahag was selected.
"F--and a number or On models whh a door latch, * The latch may have been moved, even if only slightly,
letter" flash in the display if a function error code appears fi'om the locked p(>sition. Make sure the latch ix moved
during the self-clemahlg cycle, to the right as lhras it will _>
check the oven door latch.
You have a fm_ction error code.
* Touch the CLEAR/OFFpad. ?dlow the oven to cool fin"
one heLiX: Pt/t the oven back into operation.
If the function code repeats. * Discom]ect all power to the range fin" 5 minutes
;llld then
l'eCOlll]ect })OWel:
If the
fi/llctiol] eYl'of
code repeats, call li:,r service.
Display goes blank A fuse in your home may be • Replace the filse or reset the circtfit breaker:
blown or the circuit
breaker tripped.
The clock is turned off so that it • See the Using the clock and timer secfi_>n.
does not show ha the display.
Display flashes Power failure. • Reset the clock.
Unabletoget the
Oven control
pads were
displayto show "SF"
not touched properly.
• The
BAKEand BROIL H!/LO
pads mr/st be touched at
the same time and held fin 3 seconds.
46