Using The Oven; Oven Vent; Power Outage; Oven Light - Hotpoint RGB745 Owner's Manual & Installation Instructions

Usingthe oven.
Toavoid possible bums, place the shelves in the desired position before you turn the oven on.
Before you begin...
Tile shelves have stoic-locks, so that when
I)laced correctly on tile shelf supports
(A through E), they will stop beflwe
coming completely out, and will not tilt.
\,\]/en placing and removing cookware,
pull tile shelf out to tile bum l) on tile
sheff SUl)port.
Toremove a shelf, pull it toward you, tilt tile
ti'ont end up and pull it out.
TOreplace, l)lace the end of the shelf
(stopqocks) on the sui)port, tilt up the
front and push the shelf in.
NOTE: Theshelf/s not designed to slide out at the
specb/ low shelf (R)position.
Ttie oven has 5 shelf positions.
It also has a special low shelf
position (R)for extra large items,
such as a large turkey.
Plasticitemson ttie cooktopmay
melt if left too close to ttie venL
Ventappearance andlocationvar}4
Oven Vent
Y)tu" (wen is vented through ducts at tile
rear of the range. Do not block these ducts
when cooking in tile oven--it is important
that the flow of hot air fl'om the oven
and fl'esh air to tile oven burner be
tminterrul)ted. Avoid touching tile vent
ol)enings or nearby SUlthces during oven or
broiler operation--they may become hot.
Handles ofpotsandpanson thecooktop may
become hot if left toocloseto thevenL
Donot leave plastic or flammable items on the
cooktop--they may melt or ignite if left too close
to the venL
Donot /eave c/osedcontainers on the cooktop.
Thepressure lb c/osedcontainers may increase,
which may causethem to burst.
Metal items will become veryhot if they are left
on the cooktop,and could causeburns.
Power Outage
CAUTION: Donotmakeany
attempt to operate the electric ignition oven
during an e/ectricalpower failure.
Tile oven or broiler cannot be lit during
a power fifihu'e. Gas will not flow unless
the glow bar is hot.
If tile oven is in use when a power fifilure
occurs, tile
oven b/lI'neI"
shtlts off and
cannot be re-lit until power is restored. This
is because tile flow of gas is automatically
stopped and will not resume when power
is resu)red tmtil the glow bar has reached
operating temperature.
Oven Light
Touch
tile OVEN LIGHTor "_'_ pad on tile
ul)per control panel to turn tile light on
of o JilL',
12