Switch; Headlight Lens; Edf Printed Circuit Board Assembly - Hoover WindTunnel U5465-900 Owner's Manual

2. Lift wand / hose holder out of position. Dirt
Duct is trapped into position by wand / hose
holder. On EDF models it is supplied with the
microphone. Gasket is replaceable.
Note the routing of the wiring to the switch and
microphone (where applicable) (Fig. 16).
P. Headlight Lens
1. Remove two screws and lift off lens (Fig. 17).
Fig. 17
\
\
/IICROP_" 3NE
Q. EDF Printed Circuit Board Assembly
(where applicable)
1. Remove headlight bracket screw.
2. Raise panel and board out of position
3. Unsnap four tabs to separate the board and
cover.
4. Disconnect leads and replace board.
Fig. 16
O. Switch
1. Switch is exposed once upper handle and
wand / hose holder are removed. Disconnect
leads and remove switch.
To ease reassembly of the board into the cover
remove the red and green lens, snap board into
position then reassemble both the lens.
Note: The discharge of static electricity to a
circuit board can damage the components.
When removing the circuit board from the
following precautions should be taken.
1. Avoid being statically charged when handling
board.
2. Circuit board should be handled by outside
edge only.
3. DON'T touch the metal traces (circuits) on
bottom of circuit board.