Hoover Convrtible U4097 Owner's Manual page 17

4. Replace agitator. On one end of
the agitator roll there is a raised metal
plate. Make sure that this end is
placed in groove on side of cleaner.
5. Place belt on pulley. Side of belt
nearer cleaner should be in line with
arrow on bottom of cleaner.
6. Replace metal plate. Place metal
knobs on front end of plate in wire
holders. Check to see that latches are
pushed back and will not be covered
by plate. Place plate in position and
latch securely.
The brushes
When to
replace
brushes
When brushes are worn and bristles
do not touch the edge of a card held
across the bottom plate, they should
be replaced. Always replace both
brushes at the same time to maintain
cleaning effectiveness.
What brushes to buy
When purchasing new brushes, ask for
Hoover part No. 19799. They are de-
signed to be used with your cleaner.
16