Carrying Handle; Automatic Shut Off; Brush Setting Selector; Wash/Rinse Switch - Hoover SteamVac F7210-900 Owner's Manual

Carrying handle
The deep cleaner may also be lifted by
placing a hand above the upper clean
solution tank handle as shown.
Automatic shut off
When the recovery tank (lower tank) is full
the automatic shutoff mechanism will shut
off the deep cleaner suction {suction will
be noticeably reduced).
At that time, the yellow float disk will rise
to the top of the recovery tank lid (B).
The deep cleaner will no longer pick up
dirty solution and the motor sound will
become noticeably higher in pitch.
When this happens, turn deep cleaner
off and empty recovery tank before
continuing use.
Check clean water tank also; it may
need to be refilled.
Do not use without float and float
retainer in place. If broken or dis-
lodged, take to an Authorized Hoover
Service Center or Dealer for repair.
Brush setting selector
Your 'SteamVac' deep cleaner has two
agitator brush settings.
ON - for cleaning of carpet and bare
floors
OFF - for cleaning carpets and bare
floors when brushing is not desired.
Slide selector button to the desired set-
ting before cleaning.
Wash/rinse switch
This switch allows you to easily change
from cleaning your carpet or floor with a
detergent/water mix to rinsing with water
only.
Set the switch to WASH to clean the car-
pet or floor with detergent and water.
Set the switch to RINSE to use water
only.
See "How to clean" section for more
details.
The tanks
Clean water tank
(upper tank)
The clean water tank (C) holds the water
that will either be mixed with detergent
for cleaning the carpet or floor, or used
to rinse the carpet or floor.
The detergent container (D) is perma-
nently attached to the water tank. It
holds the detergent that mixes with the
water.
How to fill
Unplug deep cleaner from electrical
outlet.
Place deep cleaner handle in the
upright, locked position.
To remove tank, press down on tank
handle and pull forward.
Continued -P 7