Wiring; Selecting Terminal Identifications For System Type; Inserting Wires In Terminal Block - Honeywell VisionPRO 8000 Owner's Manual

VisionPRO TM 8000 Touchscreen Programmable Thermostat
4. Position the wallplate over the holes, pulling wires
through the wiring opening. See Fig. 6.
5. Insert the mounting screws into the holes and tighten.
WALL
W_RES THROUGH WALL
WALL ANCHORS (2)
_a
HOLES
SCREWS(2)
Fig. 6. Mounting wallplate.
WIRING(FIG.9- 21)
All wiring must comply with local electrical codes and
ordinances.
1. Select set of terminal identifications (Table 1) that
corresponds with system type (conventional or heat
pump in Fig. 7).
2. Loosen the screws for the appropriate system type
selected; see Table 1. See Table 2 for terminal
designation descriptions. Insert wires in the terminal
block under the loosened screw. See Fig. 8.
3. Securely tighten each screw.
4. Push excess wire back into the hole.
5. Plug the hole with nonflammable insulation to prevent
drafts from affecting the thermostat.
6. See Fig. 9 through 21 for typical wiring hookups.
_c HEAT PUMP
ONVE TIONAL]
' Z SCREWTER_._,NALS J _,_
Table 1. Selecting Terminal Identifications for
System Type.
Wallplate Wiring
Terminal Diagram
System Type Identifications Reference
Standard Heat/Cool Conventional 9, 10
Heat Only Conventional 11
Heat Only with Fan Conventional 12
Heat Only (Series 20) Conventional 13
Power to open and
power to close zone
valves
Normally Open Zone Conventional 14
Valves--Heat Only
Cool Only Conventional 15
Standard Multistage up Conventional 16, 17
to 2 Heat/2 Cool
Heat Pump with No Heat Pump 18, 19
Auxiliary Heat
Heat Pump with Heat Pump 20, 21
Auxiliary Heat
Fig. 8. Inserting wires in terminal block.
IMPORTANT
Use 18 gauge thermostat wire.
Fig. 7. Selecting terminal identifications for
system type.
5 68-0280