Charging Your Battery - DieHard 200.71315 Owner's Manual

Charging Your Battery
Charging a battery in the vehicle:
1. Arrange the power cord and charging leads carefully
to avoid damage that could be caused by the hood,
door, or moving engine parts.
2. Keep clear of fan blades, belts, pulleys, and other
parts that can cause injury.
3. Check the polarity of the battery posts as indicated
on the battery case: POSITIVE (POS, P, or +) and
NEGATIVE (NEG. N or -). NOTE: The positive post
on top-post batteries is usually larger than the
negative post.
4. Identify which battery post is ground or connected to
the chassis. THE NEGATIVE POST IS
NORMALLY THE ONE THAT IS GROUNDED.
5. To charge a negative grounded post system:
Connect the red (POSITIVE) battery charger clamp
to the ungrounded POSITIVE (POS, P, +) post of
the battery. Then connect the black (NEGATIVE)
clamp to a heavy, unpainted metal part of the
chassis or engine block, away from the battery. Do
not connect clamp to carburetor, fuel lines, or sheet
metal parts.
6. Connect the clamp to the battery post and twist or
rock back and forth to make a solid connection.
This will help keep the clamps from slipping off the
posts and causing sparks.
7. For automatic charging, select AUTOMATIC DEEP
CYCLE or AUTOMATIC REGULAR as a charge type
then select a charge rate. The charger will stop
charging when the battery is fully charged.
8. For manual charging, select MANUAL as a charge
type then select a charge rate. The charger will not
stop charging when the battery is fully charged--you
must monitor and unplug charger when battery is
fully charged. Avoid overcharging, monitor the
AMMETER frequently when in the MANUAL mode.
9. Next plug the power cord into an AC outlet.
10. When the battery is fully charged, in the MANUAL
mode, the AMMETER pointer will fall to about half
the charge rate selected. For specific positions,
refer to the "Ammeter" section in "Using your battery
charger" on a page 6.
11. When the battery is fully charged, unplug the charger
power cord before attempting to disconnect charger
clamps.
12. Standing away from the battery, remove the charger
clamps In this order: (1) from the chassis
connection and, (2) from the battery post or terminal.
13. Clean and store the battery charger in a dry location.
\
NEGATIVE GROUNDED SYSTEM
7