Jumper Settings; Pci-E Disable Jumper - EVGA Classified SR-2 User Manual

Jumper Settings

PCI-E Disable Jumper

For the ease of troubleshooting multiple graphics cards or testing an
individual graphics card's overclocking, EVGA has implemented seven
jumpers you can use to disable individual PCI-E slots. You don't need to
remove any of your graphics cards but simply disable the slot the particular
card is in.
You see the location of the 7 jumpers in the above diagram. They are
located right above the 24-pin ATX Connector. In default shipping
configurations, all slots are enabled with the jumpers in the left position.
From top to bottom, PCI-E slots 1, 3, 5, 7, 2, 4, 6 respectively. To disable a
PCI-E lot, move the jumper over to the right position.
Example: Remove the Jumper cap of JPE2, PCI-E Slot 2 is disabled while
the rest are enabled. The PCI-E Disable Function can also be extended
onto the EVGA Control Panel (ECP).
Do this when the PC is turned off, NOT while it is running!
EVGA Classified SR-2 Motherboard
JPE1
JPE3
JPE5
JPE7
JPE2
JPE4
JPE6
37