GE TFX25PRBABB Owner's Manual page 7

When Your Refrigerator Is First Plugged In
All panel lights come on f_)rfive seconds,
a beep sounds, and light.s go offexcept as
follows:
PF flashes in dm display. Touch SYSTEM
CHECK-RESETto eraseit.
NORMALgIows.
; WARM TEMPglows until the refrigerator
cools doom. It goes offwhen proper food-
keeping temperature is reached.
Door alarm beeper is activated and DOOR
ALARMglows.
CRUSHED ICE glows.
DOOROPENflashes if either door is open,
goes out when doors are shut.
Night light in ice and water dispenser
is off.
How to Set the Door Alarm
To set the alarm press DOORALARMuntil it
glows.
The control beeps if either door is open for
more than 30 seconds.
The light goes out and the beeping stops
when you close the door.
Why the WARM TEMP Light Glows
At first, it's probably because your newly-
installed refrigerator hasn't COlnpletely
cooled down yet. _ait a few hours for it m
cool, and then the light will go out.
From then on, WARMTEMP xdll glow when-
ever temperatures inside get too high f_)r
proper food storage. If this happens, open
the doors only when absolutely necessary,
and close them as quickly as possible.
As soon as inside temperatures return to
normal, the light goes out.
If WARM TEMP reappears and stays on for
longer than 4 hours, call for service.
How the Monitor and Diagnostic System Works
The diagnostic code flashes and the control
beeps when something starts to go wrong.
If more than one coded traction requires
attention at the stone time, the one _4th the
highest priority will be displayed first.
Pressing SYSTEMCHECK-RESETwiII erase
two codes immediateb_PFand CLThe dE
and FFcodes can only be erased by pressing
SYSTEMCHECK-RESET;_ter the condition
that caused the code to flash has been cot:
rected.
SYSTEMCHECK-RESET_iII also evaluate
all other coded fimctions. If NORMAL is
lit during the displa}_ng of a code, that fimc-
tion is operating properly.
7