GE TFX25PRBABB Owner's Manual page 20

Installing the water line.
Read these instructions completely and carefully.
Connect the Tubing to the Refrigerator
Before making the connection to the refrigera-
tor, be sure the refrigerator power
cord is not plugged into the wall outlet.
We recommend installing a water filter if your water
supply has sand or particles that could clog the
screen of the refiigeramr's water valve. Install it in
the water line near the refrigerator.
V-_ Remove the plastic flexible cap from the water
valve (refrigerator connection).
[_-]Place tim compression nut and fetr'ule (sleeve)
onto the end of the robing as shown.
V_ Insert the end of tim copper ulbing into
file water valve refrigerator conne_:tion as fro.
as possible. _Vbile holding the ulbing, tighten
tim fitting.
V_ Fasten the copper robing into tim clamp provid-
ed to hold it in position. You m W
need to PU open the clmnp.
Oneof the illustrationsbelow will look like the connection
on yourrefrigerator.
1/4" Copper
Tubing
TubingClamp
lPression
Remove screws (sleeve)
andfold back
accesscoveE igerator
Connection
TubingClamp _--.. 1/4" Compression N ut .....
",,,,,,,,,,_{ _ _ _ I-erru,e is,eeve_
_'-'}), ) _f----_. //. Refrigerator
-_-'-_-_/ _'_,--_, jC* "-,,/ Connection
Tubing __
Turn the Water On at the Shutoff Valve
V-_ Tighten any connections that leak.
[_-]Replace the access cover and screws (on some
models).
Plug In the Refrigerator
Atr'ange the coil of copper robing so that it does not
vibrate against the back of the refrigerator or against
the wall.
Push the refrigerator back to the wall.
Start the Icemaker
Set the icemaker feeler ann to d_e ON (down) posi-
tion. The icelnaker will not begin to operate until it
reaches i_soperating telnperamre of 15°F
(O°C) or below. It will then be_n operation auto-
matically if the icemaker feeler arm is in the
ON (down) position.
NOTE:Theicemakermay double-cycle whenit first starts,
causingsome water spillagefrom the icemakerinto the
ice bucket.Thisis normaland shouldnot happenagain.
20