Drying Options; Features - GE GSD700 Use And Care Manual

HOW TO OPERATE YOUR DISHWASHER
NOTE: The lights over the Cycle pads come ON to
indicate the cycle that has been selected. These Cycle
Indicator lights remain on while the door is latched.
If dishwasher drains into a food waste disposal,
operate the disposal until it is empty before starting
dishwasher.
Step 1.
Load yore" dishwasher. (See Loading section.)
Step 2.
Make sure the Cycle Indicator Dial is at
the OFF position• Add detergent to the detergent
dispenser• (See Detergent Guide.) Use a rinse aid
agent to help prevent spotting• (See How to Use
a Rinse Agent section. )
Step 3.
Latch the door.
Step 4.
Select desired wash cycle.
• POTSCRUBBER For items such as pots, pans
and casseroles with dried-on or baked-on soils.
Everyday dishes may be included. This cycle will
get heavily soiled dishes cleaner than the normal
cycle. It will not remove burned-on foods.
• NORMAL WASH--For most loads of evewday
dishes, glasses and cookware with medium soils.
Designed to yield high performance on normal soils.
Step 5.
Select the desired drying option.
• HEATED DRY ON--Turns the &Ting heater on
for fast dwing. When selected, the cycle time will
be extended for 35 minutes.
• HEATED DRY OFF Shuts off the heating unit,
thus saving energy. Dishes air-dry naturally. It takes
longer but saves energy. You eau open the door after
the motor stops to speed drying. Excellent for
overnight drying.
I
! !
POT- NORMAL
SCRUBBER WASH
©©
Cycles
j/
®
P
features and appearance may vary slightl3;
Step 6.
Turn the Cycle Indicator Dial to START.
• Turning the dial to START will begin the cycle
inunediately. To obtain the benefits of a complete
cycle, be careful that you do not turn the dial any
farther than is necessa W to start the dishwasher.
There is a time delay between start-up and water
fill so you will not hear any wash action right away.
Dial Cycles
The SHORT WASH cycle allows you to quickly
wash loads of evewday dishes with medium soils
that have not &ied on, such as loads consisting mostly
of glasses.
a. Select the NORMAL WASH cycle and a drying
option if desired.
b. Be sure the door is unlatched.
c. Slowly turn the Cycle Indicator Dial to
SHORT WASH.
d. Latch the door to start the cycle.
The RINSE & HOLD cycle is for rinsing
partial loads which will be washed later. Do
not use dete_L,4ent.
a. Select HEATED DRY OFF.
b. Be sure the door is unlatched.
c. Slowly turn the Cycle Indicator Dial to
RINSE & HOLD.
d. Latch the door to start the cycle.
4