Preparing Re Installtherefrigeracor - GE TFX25PRYDBB Owner's Manual

Side by side profile models 22-27
Table of Contents

Advertisement

Available languages

Available languages

Preparing to install the refrigerator.
Read these instructionscompletely and carefully.
Water Supply to the Icemaker (on some
If tim refiigerator
has an icemaker, it _411 have to be
connected
to acoM water line.
A water supply kit (containing copper robing,
shutoffvalve,
fittings and instructions)
is available
at extra cost fi'om your dealer or fi'oln Parks and
Accessories, 800-626-2002.
RefrigeratorLocation
Do not install tim refrigerator where tim
temperature
will go below 60°F. (16°C.)
because it will not mn often enough to lnainmin
proper telnperatures.
Install it on a floor strong enough to support it
fitly loaded.
Clearances
Allow the fbllowing clearances far ease of
installation, proper air circulation and
plumbing and electrical connections:
Sides 5/8" (15 mm)
Top
1" (25 ram)
If built-in, allow 7/8" (22ram)for hinge covers,
If tim refrigerator is against a wall on either side,
allow the following door clearances:
22'- 25' models
3/4" (19 mm)
27' models
1%" (38 mm)
Back 1" (25 mm)
Rollers
Themilershave3 purposes:
[--_Rollers a({just so the door closes easily when
opened about halfivay. [Raise tt_e from about
5/8" (15 mm) from the
floor.]
To assure that the doors will close automatically
from a halfi_ay open position, there is a built-in tilt
from the front to the back of tim cabinet. Side-b?_
side refrigerators
also have specially designed door
hinges that lifkboth doors slightly when opened,
allowing the force ofgravib_ to help close them
securely.
[_Rollers
a@lst so the refrigerator is firmly
positioned on the floor and does not wobble.
[_Rollers
allow you to move tt_e refrigerator
away
from tt_e wall for cleaning.
To adjust the milers, remove
the base _'ille by pulling
it out at the bottom.
Turn the roller a(Ousting screws clockwise to raise
the refrigerator,
counterclockwise
to lower it. Use
an adjustable x_Tench (3/8" hex head bolt) or pliers.
Toreplace base grille, alia1 prongs on back of grille
with clamps in cabinet and push forward until _'ille
snaps into place.
17

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents