GE CSCP5UGXAFSS Owner's Manual And Installation page 11

About the automatic icemaker, ge.com
A newly installed refrigerator may take 12 to 24 hours to begin making ice.
Automatic Icemaker
Power
Switch
Icemaker
Green
PowerLight
The icemaker will produce seven cubes
per cycle----ai)i)roxilnately 100-130 cubes
in a 24-hour period, dei)ending on fl'eezer
cot/tl)at'ttllent tet/tl)et'atttt'e _ t'oot/t
teml)erature, mmg)er of door openings
and other use conditions.
See below fin" how to access ice and reach
the power switch on dispenser models.
If the reti_igerator is operated betore the
water connection is made to the icemaket;
set the power switch in the 0 (off) position.
When the refl-igerator has been connected
to the water sui)i)ly, set the power switch to
the I (on) position.
The k'emaker will fill with water when it
cools to 15°F (-10°C). A newly installed
refi_igerator may take 12 to 24 hours to begin
making ice cubes.
You will hear a buzzing sotmd each dine
the icemaker fills with water:
Throw awm the first tew batches of ice to
allow the water line to cleat:
Be sure nothing interteres with the sweep
of the feeler ram.
When the bin fills to the level of the teeler
aml, the icemaker will stop producing
ice. It is nomml tin" several cubes to be
joined together:
If ice is not used fl'equenfl> old ice cubes
will become cloudy, taste stale and shrink.
NOTE."In homes with lower-than-averagewater
pressure,you may hear the icemaker cyclemultiple
times when making onebatch of ice.
Models without a shelf
above the ice bin
Toaccessice andreach the
icemaker rowerswitch:
o Lift flTe bin, thenpull it
forwarduntil the bin
stops.
Lower the bin to access ice
or reach the power switch.
NOTE:In order to take full advantage
of the tilt-out ice bin, only store items
on the shelf below the ice bin that
are no taller than the Iowest poflTt
on the bin.
Accessing Ice and Reaching the
Power Switch on Dispenser Models
There are two types of ice storage bins on
dispenser models. One has a shelf aboxe
tile bin, the other does not.
Special note about dispenser models
without a shelf above the ice bin:
These models have a tilt-out ice bin.
The bin can be tilted out as shown ill
the illustrations, and it will hold itself
up while you take ice out or turn the
icelnaker power switch on and off.
Be sure to put the bin back in place
betore closing the door:
To restore your ice level from an empty
12 hours alter the first batch of ice
has fifllen into the bin, dispense
3 to 4 cubes.
@ _Mter an additional 6 hems, dispense
3 to 4 cubes again.
Models with a shelf
above the ice bin
Toaccessice, pullthe binforward.
Toreach the power switch, pull the
shelf straight out Always be sure to
replace the shelf.
These steps will restore your ice level
ill the shortest ai/tottnt of tilne.
11
I
,,,><,,,,,,,,,,,,,,,,,,
ii!iiiiii_i_iiiii
w
g
N"
i
H