Spark Plug - Briggs & Stratton 110000 series Operating & Maintenance Manual

MAINTENANCE
ENGINE AND ENGINE PARTS
We recommend that you see an authorized Briggs & Stratton Service Dealer for all maintenance and service of the engine
and engine parts. Use only genuine Briggs & Stratton parts.
If you perform any maintenance on the engine, first disconnect the spark plug wire
from the spark plug, and disconnect the battery at the negative terminal (electric
starter engines only) to prevent unintentional sparking. Unintentional sparking can
result in fire or electric shock. Unintentional start-up can result in entanglement,
traumatic amputation or laceration. Use only correct tools.
WARNING
WARNING
• Do not strike the flywheel with a hammer or hard object because the flywheel may
later shatter during operation.
• Do not tamper with governor spring, links or other parts to increase engine speed.
MUFFLER
_IL WARNING
Replacement parts for the muffler
must be the same and installed in the
same position as the original parts,
otherwise fire can occur.
If muffler is equipped with spark arrester screen, remove screen
for inspection. Replace screen if damaged or plugged.
SPARK PLUG
Use only Briggs & Stratton Spark Tester (part number
19368) to check for spark.
Note: In some areas, local law requires using resistor spark
plug to suppress ignition signals. If this engine was
originally equipped with resistor spark plug, use same type
for replacement.
.080" (076 mm)
WIRE GAGE
FUEL SYSTEM
_WARNING
Replacement parts for fuel system
(cap, hoses, tanks, filters, etc.)
must be the same as original parts,
otherwise fire can occur.
REPLACE FUEL FILTER (if equipped)
Drain fuel tank or close fuel shut-off valve before replacing
fuel filter. Otherwise, fuel can leak out, creating a
fire/explosion hazard.
FUEL FILTER
P/N 499638
RESISTOR P/N 491055
13