Step 1, Remove Packaging; Step 2, Install Water Line - GE Monogram ZISB420DRK Design And Installation Manual

mnstaJiation mnstructions
[STEP 1 [ REMOVE PACKAGING
CAUTJ0N:
Re{rigerator is m,wb heavier at the
top tbam_at tl]e bottom
- be carehd wl]e_ movim_g.
Whem_ i*sim_g a harold track, hm_dle H'om side orally.
PRU [)ENCE: *,e
est
pb*s ]om'd e]_ haut ql*'e]_ has. H fimt &H'e prl*de]_t ]ors
des deSp]aceme]_ts. S] m_ diab]e est i]ti]iseS, 1] fimt
sol]lever ]e re}JtHg_ratem" sin" ]e citer sel_]emem_t.
* ( areh_]]y cm bam_dim_g at d_e top amid bottom,
remove ollte]" cartom?o
* Slide om back coH_er posts (2).
* Slide carto_ off top of cabim_et.
NOTE: IT iS NOT NEC_ESSARY TO I.AY CABINET
DOWN IN ORDER TO REMOVE SKID!
* The m_it is secm'ed to the skid wit]] 4 slotted
t] e-dow_ st]:q/s. Rein ore t]]e ii_m" 5/] 6" bo]ts
_'om the base cham_m_e]s im_ the tie-do_N_s.
/
* Remove tile [ore" 7/16"
bolts secl_rim_g the straps
to the skid.
CAUTiON: DoNOT
_TTEMPT TO ROI,I,
IJNIT OFF SKI[).
Rem0 e PRUDENCE: H
TieDowns KM_T PAS ESSAVER DE
FMRE ROI/I,ER I,E
-.." Rt_FRIt;ERATEIJR POIJR
_. I,'ENI,EVER DE IAY
PAI ,ETTE.
• Sui)port blocks on the bottom of the refl'igeration
case must be removed befl>re the refl'igerator is
taken off the skid or dan]age will occm', Carefiflly;
tilt refl'igerator and slide blocks out fl'om beneath.
• Remove toekick, set aside fi>r final installation,
• I,ift the refl'igerator off the skid with an appliance
dolly, Handle fl'om the sides,
[STEP 2] iNSTALL WATER LiNE
* A cold water supply is reqlfired fl]r alltomatic
icemaker operatiom The water pressm'e must be
betweel_ 40 m_d ] 2(I p.sJ.
* Ro_*te ]/4" OD copper or GE SmartCo_ect ''_
plastic tubi_g betwee_ hoarse cold water ]]_e a_d
th e water co _1_1ecti o_1 ]oca t] oil.
* Tubing sho_*]d be ]o_g e_tmgb to exte]_d to die
_}'o_t of d_e reIHgerator. Allow e_o_gh mbh_g to
accl)mmodate beard ]eadi_g ]_to the water ]]_e
c o H H e C ti o H.
NOTE:
The o_]y GE approved plastic mbi_g is
s_q:/p]ied 1_ die GE Smarff2m_ect rxl ReiHgerator
T_bi_g ];its. Do _(]t _se a_v other plastic water s_q:/p]y
]i_e beGmse t]_e ]i_e is m_der pressm'e at a]] times.
()d_er types of plastic may crack or r_q/mre with age
_tHd caHse
_ate]" da_liage to volH" hoHle.
GE Smart(2omlect _ Re{_']gerator T_bh_g Kits are
2' (.6 m) WX08X]0002
6' ( ] .8 m) WX OSX ] 0006
15' (4.6m)
WXOSXIOO]5
25' (7.6 m) WX08X]0025
Copper Tubing J
Shut off the main water supply,
Turn on the nearest faucet long enough to clear the
line of water.
• h]stall a shut-oil' wllve between the iceu]aker water
wllve and cold water pipe in a baseu]ent or cabinet.
The shut-ott wllve should be located where it will
be easily accessible.
• Turn on the u]ain water sui)ply and flush debris.
Run about a quart of water through the tubing into
a bucket. Shut {}tt water sui)ply at the shut-ott wllve.
NOTE: Saddle tvi)e shut-otI valves are included in
many water
sui)ply kits. Before pro'chasing, make
sure a saddle type valve complies with your local
phunbing codes.
NOTE: Commonwealth
of Massachusetts Phunbing
Codes 248CMR shall be adhered to. Saddle valves
are illegal and use is not permitted in Massachusetts.
Consult with vom" licensed phunber.
11