Bosch SHE44C Use And Care Manual page 14

Operating the Dishwasher (ooot o.o¢
Oishware Drying
At the end of the cycJe the dishwasher wHJstop
and a period of condensation drying will follow.
After 12 - 15 minutes of drying:
the cycle countdown display will read "0".
the "Sanitized" light may appear (except in
the Rinse and Hold cycle). See section on
SanRization for more information.
NOTE: Jf your household water supply is too hot,
your dishwasher's heating time may be reduced
and the "Sanitized" light may not illuminate. Your
Bosch Dishwasher installation Manual has
information on the recommended temperature for
your household hot water supply.
NOTE: To accelerate and enhance drying, open
the dishwasher door, pull the top rack a few
inches out of the dishwasher, and prop the
dishwasher door against the top rack.
"Sanitized" Light
When the "Sanitized" light appears, it means that
the dishware and kitchenware that was just
washed has been sanitized according to the
requirements of the National Sanitation Foundation
(NSF). For more information on NSF certification,
go to the Wash Cycle information section of this
manual.
Unloading the Dishwasher
Unload the bottom rack first.
Unload the silverware basket(s). They are easily
removed for unloading.
Unload the top rack.
Jf the Extra Tall item Sprinkler was installed, return
the dishwasher to its normal condition (see the
Loading Extra Tall items instructions in the
"Loading the Dishwasher" section of this manual).
This feature senses when the unit is low on rinse
agent and automatically adjusts the drying
performance.
Additional Drying Heat
With this option you can raise the temperature of
the rinse water and increase the drying time,
which will result in improved drying.
Press and hold the left "Cancel Drain" button,
then press and hold the On/Off button.
When the LED display shows a "0" or a "1",
release both buttons.
To enable the Additional Drying Heat, press the
left "Cancel Drain" button until the LED display
shows a "1".
To disable the Additional Drying Heat, press the
left "Cancel Drain" button until the LED display
shows a "0".
Press the On/Off button to save the setting.
13