TYAN Tank TA26 (B5383 Service Manual page 33

Note:
against the body of the floppy drive when installed. There is
also a spring catch mechanism on the right hand rail (when
looking at the floppy disk drive from the front).
3. Plug the FDD power and data cables into the ports on the
back of the floppy disk drive.
4. Thread the cables out through the back of the empty
drive bay. Slide the floppy disk drive into the drive bay
until it clicks into place and fits flush with the front panel.
Chapter 2: Setting Up
The FDD rails each have a flat side which should be
25