Assembly Instructions - Troy-Bilt TB10CS Operator's Manual

INSTALL AND ADJUST THE D-HANDLE
1. Push the D-handle down onto the shaft housing so
that the handle slants towards the shaft grip (Fig. 1).
The squared bolt hole in the handle is to the right.
2. Insert the shoulder bolt into the squared hole in the
handle and push through. On the left side of the
handle, place the washer on the bolt, then screw the
wing nut onto the bolt. Do not tighten until you make
the handle adjustment.
3. Rotate the D-handle to place the grip above the top
of the shaft housing. Place it a minimum of 6 inches
(15.24 cm) from the end of the shaft grip.
Shaft Grip
Shaft Housing
Minimum 6 inches
(15.24 cm)
Bolt
4. While holding the unit in the operating position
(Fig. 9), position the D-handle to the location that
provides you the best grip.
5. Tighten the wing nut until the D-handle is secure.
INSTALL THE CUTTING ATTACHMENT SHIELD
Use the following instructions if the cutting attachment
shield on your unit is not installed.
WARNING:
cutting attachment shield in place to
prevent serious personal injury.
1. Place the cutting attachment shield onto the shaft
housing. Be sure the guard mounting bracket slides
into the slot on the edge of the cutting shield. Rotate
the shield into place, counterclockwise. The holes in
the guard mounting bracket and cutting attachment
shield will line up (Fig. 2).
Shaft Housing
Cutting Attachment
Shield

ASSEMBLY INSTRUCTIONS

D-Handle
Tighten
Wing Nut
Washer
Fig. 1
Never operate the
trimmer without the
Guard
Mounting
Bracket
Fig. 2
2. From inside the cutting attachment shield, push the square
bolt through the hole until the threaded end protrudes
through the guard mounting bracket (Fig. 3).
Guard
Mounting
Bracket
Square Bolt
3. Put the washer on the bolt, then screw the wing nut
onto the bolt and tighten. Figure 4 shows the
installation process from underneath the unit.
Square Bolt
Cutting
Attachment
Shield
EDGE GUIDE WHEEL
1. Remove the bolt from the edge guide wheel.
2. Push edge guide wheel onto the shaft just above the
cutting attachment shield (Fig. 5). Some force may be
required. The depth adjustment nut must be on top.
3. Install the bolt, washer, lock washer and wing nut, in
that order. Tighten securely.
4. Adjust the edging depth by loosening the depth
adjustment nut. Then move the guide wheel along the
path shown by the thick arrow (Fig. 5) until the wheel
reaches the desired position and then tighten securely.
For instructions on how to operate the edge guide wheel,
refer to page 11.
Bolt
Washer
Wing Nut
Fig. 3
Hole
Washer
Wing Nut
Cutting Attachment and
Shield: Underside View
Fig. 4
Wing Nut
Lock Washer
Depth
Adjustment Nut
Edge Guide
Wheel
Fig. 5
7