Managing The Windows Driver (For Embedded Clients); Advanced Driver Settings (For Embedded Clients) - Sharp eCopy ShareScan OP Configuration Manual

Managing the Windows driver (for embedded
clients)
This section applies only to eCopy-enabled devices with embedded clients. It is intended for
developers.
The Windows Simulator included with the eCopy ShareScan OP SDK uses the ShareScan OP
Windows driver to simulate scanning.
To manage the driver:
In the console tree, right-click
1
2 Under Manage ShareScan OP Driver
"Advanced driver settings (for embedded clients)" on page 39).
3 Under Driver
Under
4 Manager parameters
which the client is connected, enter the port number used for client-manager communication.
The port number must match the port specified for the manager (see "To specify general
properties:" on page 22).
Click .
5 Save

Advanced driver settings (for embedded clients)

Use the Advanced driver settings only when testing or troubleshooting. Do not enable these options
in a production environment.
The following settings are available:
— Select this option to enable test mode (for testing only). This enables you to
■ Scan File
configure ShareScan OP for testing without an attached scanner. When configured this way,
ShareScan OP uses a TIFF file on the local hard drive to simulate the scanning process.
— Enter the full path and file name of the TIFF file to use (multi-page Group 3 or
■ File (TIFF)
Group 4 TIFF files are supported).
Logging — Select this option to enable driver logging -- for testing only, and only if eCopy
■
Technical Support asks you to do this. This option records all client-manager transactions in a
log file on the client computer.
Devices
, start or stop the driver as needed.
, which displays the host name or IP address of the manager to
eCopy ShareScan OP Configuration Guide | 39
> >
device_name Manage
, click Advanced to specify additional driver options (see
.