Audio Setup; Audio Select; Fine Sync - Sharp LC-32LE440U Operation Manual

On-Screen Display Menu
Change CC
Allows you to change the Closed Caption
display.Select "Change CC" on the menu to
display the Closed Caption information.
• You can change Closed Caption by pressing CC on
the remote control unit.See page 24 for details of
Closed Caption function.
Input Terminal Setting

Audio Setup

You can output digital audio to an AV amplifi er
or similar device whose DIGITAL AUDIO INPUT
terminal is connected to the DIGITAL AUDIO
OUTPUT terminal on the TV. Please select an
audio output format compatible with the audio
format of the program you are watching and
the equipment connected.
PCM: The optical output terminal outputs
audio signal in PCM form. If your digital
audio system does not support Dolby
Digital, select "PCM".
Dolby Digital: The optical output terminal
outputs audio signal in Dolby Digital form. It
reproduces sound from surround program
of digital.
Off: Disables digital audio output.
PC Input
Auto Sync. (for Analog PC Input Mode Only)
The Auto Sync. is only available when the
input source is PC and your TV is receiving a
computer signal. Select Auto Sync. For
adjusting the settings automatically.
• Be sure to connect the PC to the TV and switch it
on before starting "Auto Sync.".

Fine Sync.

Ordinarily you can easily adjust the picture as
necessary to change image position using
"Auto Sync.". In some cases, however, manual
adjustment is needed to optimize the image.
H-Pos.: Centers the image by moving it to
the left or right.
32
V-Pos.: Centers the image by moving it up
or down.
Clock: Adjust when the image flickers with
vertical stripes.
Phase: Adjust when characters have low
contrast or when the image flickers.
• The default cursor position may not be in the center,
because the screen position variable ranges may be
asymmetrical.
• The screen position variable ranges depend on the
View Mode or the signal type. The ranges can be
seen on the position-setting screen.

Audio Select

This function sets the terminal to output the
computer audio.
The adjustment items vary depending on the
input source. Select the input source
corresponding to the terminal connected to the
PC and then adjust the desired item.
PC IN
Video: Select this when the TV and PC are
connected using an analog RGB cable and
the audio is not input.
Video+Audio: Select this when the TV and
PC are connected using an analog RGB
cable and the audio is input via a Ø 3.5 mm
stereo minijack.
HDMI IN
Auto: Audio Selected automatic,the default
setting is
"Auto".
HDMI(Digital): Select this when the TV and
PC are connected using an HDMI-certified
cable and audio is input via the same cable.
HDMI+Analog: Select this when the TV and
PC are connected using a DVI-HDMI
conversion cable and the audio is input via a
Ø 3.5 mm stereo minijack.
• When "Audio Select" is set to "HDMI(Digital)", sound
will not be produced if you use only an
HDMI-certified cable to connect HDMI-compatible
equipment. To produce sound, you should make an
analog audio connection.
• If you want to connect HDMI-compatible equipment
using only an HDMI-certifi ed cable, set "Audio
Select" to "HDMI(Digital)".