Table of Contents
Advertisement
General control
To turn the power on
The fi rst time the unit is plugged in, the unit will enter the
demonstration mode.
Function
Main unit
Power on/
off
____
Demo on/
off
Display brightness control
To dim the display brightness, press the DEMO/DIMMER
button on the remote control.
Volume auto fade-in
If you turn off and on the main unit with the volume set to
27 or higher, the volume starts at 16 and fades in to the
last set level.
Volume control
Turn the volume knob towards VOL +/- (on main unit) or
press VOLUME +/- (on remote control) to increase or
decrease the volume.
Auto power on function
When you press any of the following buttons, the unit turns
on.
®
iPod
/ iPhone, CD, USB, AUDIO IN, TUNER (BAND)
on the remote control: Selected function is activated.
button on the main unit: The unit turns on and
playback of the last function will start (CD, TUNER,
USB, iPod, AUDIO IN).
Remote
Operation
control
Press to turn the
power on or to
go to stand-by
mode.
Press to enter to
demonstration on
or off mode.
Auto power off function
The main unit will enter the stand-by mode (when iPod/
iPhone is not docked) after 15 minutes of inactivity during:
iPod/iPhone: No connection.
AUDIO IN: No detection of input signal or very low sound
audibility.
TUNER: No reception of broadcast signal.
CD / USB: In the stop mode.
Note:
However, if iPod/iPhone is docked, the unit will begin
charging.
"CHARGE MODE" will be displayed.
Muting
The volume is muted temporarily when pressing the
MUTE button on the remote control. Press again to restore
the volume.
X-Bass control
When the power is fi rst turned on, the unit will enter the
extra bass mode which emphasises the bass frequencies,
and "X-BASS" will appear. To cancel the extra bass mode,
press the X-BASS button on the remote control.
Bass control
1
Press the BASS/TREBLE button to select "BASS".
2
Within 5 seconds, press the VOLUME (+ or -) button
to adjust the bass.
Treble control
1
Press the BASS/TREBLE button to select "TREBLE".
2
Within 5 seconds, press the VOLUME (+ or -) button to
adjust the treble.
Equalizer
When the EQUALIZER
MODE button is
pressed, the current
mode setting will be
displayed. To change to
a different mode, press
the EQUALIZER MODE
button repeatedly until
the desired sound mode
appears.
Function
When the FUNCTION button on main unit is pressed, the
current function will change to different mode. Press the
FUNCTION button repeatedly to select desired function.
CD
FM STEREO
AUDIO IN
Note:
The backup function will protect the memorised function
mode for a few hours should there be a power failure or
the AC power lead becomes disconnected.
E-4
Equalizer off.
FLAT
For game.
GAME
CLASSIC
For classical music.
For pop music.
POPS
Vocals are enhanced
VOCAL
For jazz.
JAZZ
FM MONO
iPod
USB
AM
Advertisement
Table of Contents
