Table of Contents
Advertisement
Enhancing your system
Portable
audio player,
etc.
Audio cable
(not supplied)
The connection lead is not included. Purchase a
commercially available lead as shown below.
Listening to the playback sounds of
portable audio player, etc.
1
Use a connection lead to connect the portable audio
player etc. to the AUDIO IN socket. When using video
equipment, connect the audio output to this unit and
the video output to a television.
2
Press the ON/STAND-BY button to turn the power on.
3
Press the AUDIO IN button on the remote control or
FUNCTION button repeatedly on main unit to select
AUDIO IN function.
4
Play the connected equipment. If volume level of the
connected device is too high, sound distortion may
occur. Should this happen, lower the volume of the
connected device. If volume level is too low, increase
the volume of the connected device.
Note:
To prevent noise interference, place the unit away from the
television.
Headphones
Do not turn the volume on to full at switch on and listen
to music at moderate levels. Excessive sound pressure
from earphones and headphones can cause hearing
loss.
Before plugging in or unplugging the headphone,
reduce the volume.
Be sure your headphone has a 3.5 mm (1/8") diameter
plug and impedance between 16 and 50 ohms. The
recommended impedance is 32 ohms.
Plugging in the headphone disconnects the speakers
automatically. Adjust the volume using the VOLUME
control.
Troubleshooting chart
Many potential problems can be resolved by the owner
without calling a service technician.
If something is wrong with this product, check the following
before calling your authorised SHARP dealer or service
centre.
M I C RO C O M P O N E N T S Y S T E M
9P
XL-DH25
E-13
General
Symptom
The clock is not
Did a power failure occur?
set to the correct
Reset the clock. (Refer page
time.
11)
When a button is
Set the unit to the power
pressed, the unit
stand-by mode and then turn
does not respond.
it back on.
If the unit still malfunctions,
reset it. (Refer page 15)
No sound is
Is the volume level set to
heard.
"MIN"?
Are the headphones
connected?
Are the speaker wires
disconnected?
CD player
Symptom
Playback does
Is the disc loaded upside
not start.
down?
Playback stops
Does the disc satisfy the
in the middle or
standards?
is not performed
Is the disc distorted or
properly.
scratched?
Playback sounds
Is the unit located near
are skipped, or
excessive vibrations?
stopped in the
Is the disc very dirty?
middle of a track.
Has condensation formed
inside the unit?
Remote control
Symptom
The remote
Is the AC power lead of the
control does not
unit plugged in?
operate.
Is the battery polarity
correct?
Are the batteries dead?
Is the distance or angle
incorrect?
Does the remote control
sensor receive strong light?
Tuner
Symptom
The radio makes
Is the unit placed near the
unusual noises
TV or computer?
continuously.
Is the FM aerial or AM loop
aerial placed properly? Move
the aerial away from the AC
power lead if it is located
nearby.
Possible cause
Possible cause
Possible cause
Possible cause
Advertisement
Table of Contents
