Remote Control - Sharp XL-DH259P Operation Manual

System connections (continued)
Warning:
The voltage used must be the same as that specifi ed
on this unit. Using this product with a higher voltage
other than that which is specifi ed is dangerous and
may result in a fi re or other type of accident causing
damage. SHARP will not be held responsible for any
damage resulting from use of this unit with a voltage
other than that which is specifi ed.
To prevent fi re or shock hazard, do not expose this
appliance to dripping or splashing. No object fi lled
with liquids, such as vases shall be placed on the
apparatus.
Speaker connection
Use speakers with an impedance of 4 ohms or more,
as lower impedance speakers can damage the unit.
Do not make a mistake when connecting the right and
left speakers. The right speaker is the one on the right
side when you face the unit.
Insert the speaker plug fully with the lever side facing
to the left.
Hold the speaker plug when removing it from the unit.
Pulling the wire may cause malfunction to the unit.
Do not allow any objects to fall into or to be placed in
the bass refl ex ducts.
Do not stand or sit on the speakers. You may be
injured.

Remote control

Battery installation
Use 2 "AAA" size batteries (UM/SUM-4, R3, HP-16 or
similar). Batteries are not included.
Plastic fi lm covering can be removed or peeled off.
1
Open the battery cover.
2
Insert the batteries according to the direction indicated
in the battery compartment.
When inserting or removing the batteries, push them
towards the battery terminals.
3
Close the battery cover.
Caution:
Replace all old batteries with new ones at the same
time.
Do not mix old and new batteries.
Remove the batteries if the unit will not be used for a
long period of time. This will prevent potential damage
due to battery leakage.
Do not use rechargeable batteries (nickel-cadmium
battery, etc.).
Installing the batteries incorrectly may cause the unit
to malfunction.
Batteries (battery pack or batteries installed) shall not
be exposed to excessive heat such as sunshine, fi re
or the like.
Notes concerning use:
Replace the batteries if the operating distance is
reduced or if the operation becomes erratic.
Periodically clean the transmitter on the remote control
and the sensor on the unit with a soft cloth.
Exposing the sensor on the unit to strong light may
interfere with operation. Change the lighting or the
direction of the unit.
Keep the remote control away from moisture, heat,
shock, and vibrations.
E-3