Replacing Disc In Round Dvd Holder; When The Hinge Of Round Dvd Holder Comes Off; Disc Cleaning - Hitachi DZ-MV1000E Instruction Manual

REPLACING DISC IN ROUND DVD HOLDER

1
Open SIDE A of the Round DVD Holder, and
replace the disc in the holder with the SIDE A
mark or label surface facing up, taking care not
to touch the disc surface.
OPEN marks
SIDE A mark side or
label surface

WHEN THE HINGE OF ROUND DVD HOLDER COMES OFF

1
Push the hinged portion of the holder piece
marked SIDE A with thumb and middle finger,
and warp it in the direction of arrows (4).
SIDE A mark side
Approx. 90°

DISC CLEANING

Use a soft, dry cloth to lightly wipe off any dust,
dirt, etc. adhering to disc, as shown in the figure.
Never use solvent. Do not use thinner, water, anti-
static spray, etc. to clean disc.
76
3
SIDE A
mark
3
Hinged portions
4
Use soft cloth to clean
from inner to outer
circumference in axial
direction.
2
Close SIDE A of the Round DVD Holder, and
push it to lock the release levers at positions (3).
2
Fit the hinged portion of the other holder piece
into the warped hinge portion.
:
Note
•
Handle the disc carefully so that no scratch, dirt,
fingerprint or dust adheres to the recording/playback
surface.
•
When not using the Round DVD Holder, store it in case:
Do not leave a bare holder as is.
•
Be careful of drop or impact: If you drop the Round DVD
Holder, the disc may pop out.
•
Do not subject the Round DVD Holder to force.
12
12
12