Table of Contents
Advertisement
Inserting and Removing Disc
1
Press down the DISC EJECT button once and
release it.
A few moments after the ACCESS/PC
indicator blinks, the cover of disc insertion
block will open.
2
Gently open the cover by hand fully until it
stops.
DISC EJECT
3
When inserting a disc:
Push the disc against the turntable at the
centre to lock it until a click is heard.
Push the shaded
portion.
When removing the disc:
While pushing down the centre portion of
turntable, pick up the disc, holding its edge,
to remove it.
Turntable
• Note that the recording surface of disc must face
the inside of DVD video camera/recorder. When
using a single-sided disc, the recording surface is
the side without label.
• Never touch the disc recording surface or pickup
lens. Touching the pickup lens could cause a fault.
• Use the disc cleaning cloth provided to wipe off
any dirt adhering to the disc recording surface.
• Do not use a dirtied or scratched disc.
4
Push the section marked "PUSH CLOSE" on
the cover of disc insertion block, to close the
cover.
Then the DVD video camera/recorder will
automatically recognise the disc: While the
ACCESS/PC indicator is lit, do not cut off the
power supply, and do not subject the DVD
video camera/recorder to any vibrations or
impact.
Pickup lens
39
Advertisement
Table of Contents
