Table of Contents
Advertisement
During recording
Symptom
Pressing the REC or
PHOTO button will not
start recording.
Recording starts but
stops immediately.
LCD screen is hard to
see.
Unevenness appears on
LCD monitor screen.
Focus is not correct.
An error message for
repair appears.
Cause and Correction
• Is a finalised disc in the DVD video camera/recorder?
• Is proper type of disc or card inserted?
• Is power switch set to match the recording medium?
When using DVD-RAM disc.
When using SD memory card: Set to " ".
• Is the disc protected or the card locked?
• Does disc or card have remaining recording space?
Is disc scratched or does dirt or fingerprint adhere to it?
Clean the disc. If there is still no improvement, replace the disc.
Has brightness of LCD screen been adjusted?
Stop recording and adjust the brightness.
Is the DVD video camera/recorder being used outdoors?
Use the viewfinder. When using LCD monitor, adjust its angle so
that LCD screen is not exposed to direct sunlight.
Did you press the LCD monitor or the area around it?
If the LCD monitor is pressed, some unevenness will occur.
Release your hand and leave the LCD monitor for a while:
Normal display will be restored.
Is it difficult to use auto focus with your subject?
Focus manually.
Does "MF" appear?
The DVD video camera/recorder is set to manual focus. Focus
the subject manually, or release manual focus.
Is the dioptre control correctly adjusted if you are using the
viewfinder as a monitor?
Adjust the dioptre control.
In cases other than the above, set the power switch to "OFF", and
then set it to "
", "
" or "
Repair is only possible when the DVD video camera/recorder is
powered by the AC adapter/charger. Remove the disc, and then
insert another disc: The removed disc can later be repaired by
connecting the AC adapter/charger.
" again.
Reference
page
26, 32, 86,
100, 110
11
37
33
—
55
54
33
32
27
139
Advertisement
Table of Contents
