Using Inserts; Saving/Recalling Settings - Focusrite Saffire Pro 26 I/O User Manual

Using Inserts

There are two available Inserts on Saffire PRO, for Inputs 1 and 2, activated by the corresponding INSERT switches within
SaffireControl PRO:
Click switch to activate Insert 1
(uses Line Input 5)
Click switch to activate Insert 2
(uses Line Input 6)
These inserts are routed using the Line Inputs on the front panel, Input 6 becoming Insert 1 (for Input 1) and Input 5 becoming
Insert 2 (for Input 2). When both Inserts are active, the XLR Inputs (for Inputs 5 and 6) can still be used to record and won't be
inactive unless the Insert switches are disengaged. In Insert mode, Input 5/6 becomes a send and return for the corresponding
Input. As such, a splitter cable is required (one TRS Jack going to two TS Jacks). For anyone wishing to make their own cables,
the Tip of the TRS Jack (plugged into the Line Input) is the send signal and the Ring is the return.

Saving/Recalling settings

The SAVE switch within SaffireControl PRO allows the software settings to be saved as a file to the computer's hard disk for instant
recall at a later date:
Click to recall SaffireControl PRO settings
Click to save SaffireControl PRO settings
Clicking the switch brings up a standard browser window where the file can be named and placed in any desired location. The file
will appear with the extension .sfpro.
To recall the settings, simply click the LOAD button and then navigate to the desired file on your computer.
Saffire PRO 26 i/o
User Guide
17