Using The Flash - Hitachi DZ-BD70E Instruction Manual

CARD

Using the Flash

As shutter speed will slow down
when still photos are recorded in dim
lighting, camera shake may easily
occur. We recommend you use a flash
in this case.
Normally, the flash fires
automatically depending on the
recording conditions (during Auto).
You can also set the flash to On
(always fires) or Off (does not fire).
Flash mode
Auto
The flash fires only when necessary.
When the flash is needed, "
appears in the LCD monitor when you
press PHOTO halfway, and then the
flash fires when you press PHOTO
all the way.
On
" " is displayed in the LCD
monitor all the time. The flash always
fires when you fully press PHOTO.
Off
" " is always displayed in the
LCD monitor and the flash will not
fire.
Selecting a flash mode
During recording pause, press
1
MENU.
Select "Camera Functions Setup"
2
"Flash" a flash mode
82
Press the confirmation button to
confirm, then MENU to end.
• To check where the flash icon
appears in the LCD monitor,
see p.50.
• The flash setting is retained in
memory even when the power
3
is turned off.
• If "Off" or "On" is selected,
and you do not plan to record
with that flash mode all the
time, we recommend you
return the setting to "Auto"
after recording and before
turning off the power.
Hints
"
• There may be cases when the
recorded pictures are out-of-
focus in dark places even if the
flash is used. We recommend
you shine a light on the subject
for recording in dark places.
• "
monitor while the flash is
recharging and the flash will
not fire.
• When recording stills up close,
set "Flash" setting to "Off". If
the subject is too close, image
smearing may occur.
Notes
• When a conversion lens is
attached, the flash cannot be
used. Adjust the "Flash" setting
to "Off".
" flashes in the LCD