Advertisement
•
Insert the curved end of chute tube into the hole in
the grass bag cover following Figure 8.
Figure 8
•
54-inch decks only: Slide the side of the chute
extension without notches into the open end of the
chute tube. Hold the chute extension in place with
your hand.
NOTE: If you are installing this bagger on a 50-inch
deck, ignore the chute extension included in the kit.
•
Insert the lower end of the chute tube or the chute
extension, as the case may be, over the discharge
chute so that its two notches fit into the two
corresponding notches on the discharge chute.
See Figure 9.
•
Secure by placing the ends of the two short retainer
straps on the discharge chute over the pins on the
chute tube. See Figure 9.
Insert chute tube here
Attaching the strap
Discharge Chute
Operation
Your triple bagger kit is a valuable accessory to your
tractor. Optimize its performance by operating
correctly. Do not try to fit it to tractors other than those
specified on page 5.
•
Open the grass bag cover by lifting the cover up.
Do not remove the chute tube assembly from the
tractor.
•
Remove the grass bags by lifting up and moving
the bags away from the support tube assembly.
•
To empty the grass clippings at a proper disposal
sight, use the handle at the bottom of each grass
bag. Holding the bag firmly, empty the contents.
•
Under normal usage, the grass bags are subject
to wear and tear. Check these bags periodically
and wash with water if dirty. Allow to air-dry; do
not apply heat.
9
Place short
strap here
Place long
strap here
Figure 9
Advertisement
