Table of Contents
Advertisement
Assembling Discharge Chute
•
Attach retainer hook, from Group E of hardware
pack, to the blank hole on the deck as shown in
Figure 12. Secure with a self-tapping screw.
•
Attach one of the two retainer straps to the
discharge chute with a hex bolt, flat washer and
flange nut as shown in Figure 13. Repeat with the
second retainer strap on the other side.
•
Attach the chute strap to the discharge chute at the
remaining hole with a hex bolt, flat washer and
flange nut. See Figure 13.
•
Position the 12" trim seal along the top edge of the
discharge chute assembly as shown in Figure 13,
then press the trim seal fully onto the edge.
NOTE: Any or all these straps may already be pre-
assembled at the factory. If so, proceed to next step.
Flat Washer
Chute
Strap*
Chute
Extension
Retainer Strap*
Flange Nut
* May already be pre-assembled
Figure 13
•
Raise the deck to its highest position.
•
Raise the chute deflector on the deck and hold it
while you position the discharge chute over the
chute opening.
•
Insert the hinge pin of the discharge chute into the
tube on the chute stop bracket. See Figure 14.
•
Rotate chute around the deck so that its bottom
edge fits under the deck opening and the top edge
fits over the back edge of the deck.
•
Lower the chute deflector slowly.
Flange Nut
Trim Seal
Hex Bolt
Flat Washer
•
Attach chute strap to the retainer clip on the deck.
Discharge
Chute
Hinge Pin
•
Insert a grasscatcher pin through the hole on the
chute tube as shown in Figure 15. Secure it with a
flange lock nut from inside the chute tube. Both are
in Group E of the hardware pack.
•
Attach the remaining grasscatcher pin at the
second hole on the chute tube.
Chute Tube
•
Insert the lower end of the chute extension over the
discharge chute so that its two notches fit into the
two corresponding notches on the discharge chute.
•
Insert the curved end of the chute tube into the hole
in the grass bag cover.
•
Insert the other end of the chute tube into the open
end of the chute extension. Refer to Figure 13.
9
Chute Deflector
Insert hinge
pin here
Figure 14
Grasscatcher
Pin
Flange Lock
Nut
Figure 15
Advertisement
Table of Contents
