Battery Charge - Panasonic KX-TG7100 Operating Instructions Manual

TG7100-7120E(e).book Page 10 Tuesday, July 4, 2006 3:29 PM
Preparation
2
Insert the batteries negative (T)
terminal first. Close the handset cover.

Battery charge

Place the handset on the base unit or
charger for about 7 hours before initial
use.
When charging, the battery icon is shown as
follows.
When the batteries are fully charged, 5
remains on the display.
L The charge indicator lights up when the
handset is placed on the base unit or
charger.
*1
Base unit Charger
Charge
contact
*1 The pictured model is KX-TG7100.
*2 KX-TG7102, KX-TG7103, KX-TG7122,
and KX-TG7123 only
Note:
L It is normal for the handset to feel warm
during charging.
10 Helpline Tel. No.: U.K. 08700 100 076 R.O.I. 01289 8333
L If you want to use the unit immediately,
charge the batteries for at least 15
minutes.
L Clean the charge contacts of the handset,
base unit, and charger with a soft, dry
cloth once a month, otherwise the
batteries may not charge properly. Clean
more often if the unit is exposed to grease,
dust or high humidity.
Battery strength
Battery icon
5
6
7
Panasonic Ni-MH battery performance
(included batteries)
Operation
In continuous use
In continuous
standby mode
Note:
*2
L It is normal for batteries not to reach full
capacity at the initial charge. Maximum
battery performance is reached after a few
complete cycles of charge/discharge
(use).
L Actual battery performance depends on a
combination of how often the handset is in
use and how often it is not in use
(standby).
L Battery operating time may be shortened
over time depending on usage conditions
and ambient temperature.
L Even after the handset is fully charged,
the handset can be left on the base unit or
charger without any ill effect on the
batteries.
L The battery strength may not be displayed
correctly after you replace the batteries. In
Battery strength
High
Medium
Low
When flashing: Needs
to be charged.
Operating time
17 hours max.
180 hours max.