Palm Handhelds m100 Handbook page 146

HotSync
Enabled/
Disabled
Enable
HotSync
software at
system startup
Show more
detail in
HotSync Log
3. If you are using the optional serial cradle/cable, click the Serial
Port Settings tab and select any of the following options.
Note: If you are using the USB cradle/cable, you do not need to
adjust the settings on the Serial Port Settings tab for a direct
HotSync operation; they are automatically set when you
perform the first HotSync operation.
Page 138
Activates the serial port monitor and prepares
your Macintosh to synchronize with your
handheld. By default, the serial port monitor is
enabled whenever you start your Macintosh.
Keep this default if your cradle/cable is
always connected to a specific port (USB,
serial, or modem). If, however, you use the
same port for other devices besides the cradle/
cable, disable the serial port monitor and then
enable it manually only when you connect the
cradle/cable to perform a HotSync operation.
Activates the serial port monitor automatically
each time you start your computer. If this
option is not checked, you must open HotSync
Manager and select the Enabled option before
you can perform a HotSync operation.
Includes more troubleshooting information in
the log that is generated when you perform a
HotSync operation.
Advanced HotSync® Operations