Connect Battery; Install Seat - Craftsman 917.252711 Owner's Manual

E LY
CONNECT BATTERY (See Fig. 2)
CAUTION: Do not short battery termi-
nals° Before connecting battery, re-
move metal braceaets, wristwatch
bands_ rings, etc°
Positive termina_ must be connected
first to prevent sparking from accideno
tal grounding.
Lift hood to raised position.
, Open terminal access doors, remove terminal protec-
tive caps and discard.
If this battery is put into service after month and year
indicated on labe[ ([abe[ located between terminals)
charge battery for minimum of one hour at 6o10 amps.
First connect RED battery cable to positive (+.)battery
terminal with hex bolt, fial washer, lock washer and hex
nut as shown. Tighten securely_
o Connect BLACK grounding cable to negative (_) bat-
tery termina! with remaining hex boIt, flat washer, lock
washer and hex nut. Tighten securely.
Ctose terminal access door&
Use terminal access doors for:
• Inspection for secure connections (to tighten hard_
ware).
Inspection for corrosion.
o Testing battery.
Jumping (if required).
o Periodic charging.
DISCARD
TERMINAL
PROTECTIVE
CAPS
HEX NUT LOCK FLAT
WASHER WASHER
BEX
INSTALL SEAT (See Fig. 3}
Adjust seat before tightening adjustment knob.
o Remove cardboard packing on seat pan.
Ptace seat on seat pan and assemble shoulder bolt.
o Assemble adjustment knob and fiat washer loosely.
Do not tighten°
Tighten shoulde__bolt secL_rely.
Lower seat into operating position and sit on seat.
o Slide seat until a comfortable position is reached which
allows you 1o press clutch/brake pedal all the way
down.
Get off seat without moving its adiusted position.
Raise seat and tighten adjustment knob securely.
SEAT
SEAT PAN
SHOULDER
BOLT
ADJUSTMENT
KNOB
FroG.3
FLAT WASHER
POSiTiVE
(RED)
CABLE
NEGATIVE
(BLACK)
CABLE
VENT HOLE
(KEEP CLEAN)
F_Go2